|
 |
| . |
| |
- Special raised rear panel is ideal for filing cabinets.
- A unique new way to assemble a drawer by clipping on a matching back panel.
- This not only improves the look of the drawer but also saves valuable time during assembly and brings down cost.
- Tilt and remove capability with guiding.
- Autoclosing of drawer.
- Front facia adjustment.
- Precision rollers for smooth running.
- 'System 32' Compatible.
| FPQ 125-40-40 F |
125 |
400 |
400 |
325 |
25 |
Powder
Coated
Black,
Brown
& Ivory. |
| * FPQ 125-40-40 FG1 |
125 |
400 |
400 |
| FPQ 125-40-45 F |
125 |
400 |
450 |
| * FPQ 125-40-45 FG2 |
125 |
400 |
450 |
| FPQ 125-45-40 F |
125 |
450 |
400 |
375 |
| * FPQ 125-45-40 FG3 |
125 |
450 |
400 |
| FPQ 125-45-45 F |
125 |
450 |
450 |
| * FPQ 125-45-45 FG4 |
125 |
450 |
450 |
| * with Gallery fitting set |
|
|
| |
- Side gap of 15.5mm is required and acts as side panel of drawer (Fig. 1).
- Fixed slide should be set by 2mm for 'Auto-closing' (Fig. 2).
- Screws should be recessed to avoid fouling.
- Fixed slides should be fitted parallel and at equal heights to each other.
- Insert the raised rear panel on to the side panels through the key slot provided in the side panels (Ref. Fig.3).
- Slide the 6mm bottom panel through the tracks provided in the side panels. (Ref. Fig. 4).
- Connect the cross rods by using T-connectors as shown in diagram (Ref. Fig. 5).
- 8. Screw the font facia with side panels and insert the dowel in to the Ø8mm hole made in front facia, screw the side rods in to the dowels (Ref. Fig. 6). Push the other end of the rod in to the plastic sleeve fitted on the raised rear panel (Ref. Fig. 7).
|
|
|
|
