Special Features

• Special Raised rear panel is ideal for filing cabinets.
• A unique new way to assemble a drawer by clipping on a matching back panel.
• This not only improves the look of the drawer but also saves valuable time during assembly and brings down cost.
• Full extension of drawer provided.
• Tilt and remove capability with guiding.
• Autoclosing of drawer.
• Front facia adjustment.
• Precision rollers for smooth running.
• System 32 compatible.

Specifications

Fitting Instructions

1. To install Full Panel Full Extension Drawer Slide a 15.5 mm gap per side is required between cabinet and drawer. A total of 31 mm for both sides. (Ref.Fig.1)
2. Insert the Raised Rear panel onto the side panels through the key slot provided in the side panels. (Ref. Fig.2)
3. Slide the 6 mm bottom panel through the tracks provided in the side panels.( Ref. Fig.3)
4. Connect the cross rods by using T- connectors as shown in diagram.(Ref.Fig.4)
5. Fix the front facia with side panels by using the clip-on mechanism and lock it by rotating the lever as shown in diagram and insert the dowel into the Ø8 mm hole made in front facia and screw the rods in it. (Ref. Fig. 5). Push the other end of the rod into the plastic sleeves fitted on the Raised rear panel. (Ref. Fig.6)
6. Fit the fixed slide onto the inside of the cabinet. Leave 6 mm from the front edge. (Ref. Fig.7)
7. Assemble the intermediate slide with the fixed slide and slide it forward till it stops. (Ref. Fig. 8)
8. Slide the File drawer assembly into the intermediate slide. (Ref. Fig.10). Make sure that the slide latches(red colour) are pulled forward.(Ref.Fig.9B) After engaging the drawer assembly into the intermediate slide move the slide latches backward to the locked position.(Ref.Fig.9A)
9. For removal of drawer, move slide latches(Red color) forward. The drawer can now be tilted and removed. (Ref. Fig. 9B)
10. Slides should be fitted parallel to each other and screws tightened fully, to avoid gaps or interference with wheels.