.
 

Special Features

  • A unique new way to assemble a drawer by clipping on a matching back panel.
  • This not only improves the look of the drawer but also saves valuable time during assembly and brings down cost.
  • Tilt and remove capability with guiding.
  • Full extension of drawer provided.
  • Slide latches and wheel catches provided on both sides to prevent the slides from getting disengaged while working.
  • 'Auto-Closing' of drawer.
  • Front facia adjustment.
  • Ribbed for strength.
  • 'System 32' Compatible.
  • 25 Kgs. of load capacity.

 

Specifications

Code No. Height Depth Width Extention Max Load kgs Finish
FPQ 125-40-40 125 400 400 435 25 Powder Coated Black, Brown & Ivory.
FPQ 125-40-45 125 400 450
FPQ 125-45-40 125 450 400 485
FPQ 125-45-45 125 450 450

 

Fitting Instructions

  1. To install Full Panel Full Extension Drawer Slide a 15.5mm gap per side is required between cabinet and drawer. A total of 31 mm for both sides. (Refer Fig.1)
  2. Insert the Rear panel onto the Side panels through the key slot provided in the side panels. (Ref. Fig.2)
  3. Place the bottom flap through the track provided in the Side panels and fix the front facia with the Bracket.(Ref. Fig.3)
  4. Fit the outer slide onto the inside of the cabinet. Leave 6 mm from the front edge. (Refer Fig.4)
  5. Assemble the intermediate slide with the outer slide and slide it forward till it stops. (Refer Fig. 5)
  6. Complete the drawer by adding front, back and bottom panels to the Full Panel, Make sure the slide latches (red color) is pulled forward. (Refer Fig. 6B)
  7. Slide the Full panel into the intermediate slide. Refer Fig.7. Move the slide latch backward to the locked position. (Ref. Fig.6A)
  8. For removal of drawer, move slide latches(Red color) forward. The drawer can now be tilted and removed. (Ref. Fig.6B)
  9. Slides should be fitted parallel to each other and screws tightened fully, to avoid gaps or interference with wheels.